Toro 30230 Groundsmaster 225, Руководство оператора

Страница: 23 / 32

Wipe inside of air cleaner body with a damp cloth to
remove excess dust. Slide filter into air cleaner body
and secure it in place with wing nut and gasket.
Reinstall dust cup and baffle. Move thumb screw
behind air cleaner body and tighten it securely.
Place bright light inside filter.
Rotate filter slowly while checking for cleanliness,
ruptures, holes, and tears. Replace defective filter
element.
Check fin assembly, gasket, and screen for
damage. Replace filter if damage is evident.
To prevent the engine from overheating, the screen
and front of the radiator must be kept clean. Normally,
check the screen and front of radiator daily and, if
necessary, clean any debris off these parts. However, it
will be necessary to check and clean the screen and
radiator frequently in extremely dusty and dirty
conditions.
*.# If engine shuts off due to overheating, first check
the radiator and screen for excessive buildup of debris.
To thoroughly clean the radiator:
Remove the screen.
Working from the fan side of the radiator, either
spray the radiator with a water hose or blow with
compressed air.
After the radiator is thoroughly cleaned, clean out
debris that may have collected in the channel at the
radiator base.
Clean and install the screen.
Check oil level after each day's operation or each time
machine is used. Change oil and filter after first 50
hours and after every 200 hours of operation thereafter.
If possible, run engine just before changing oil
because warm oil flows better and carries more
contaminants than cold oil.
Position machine on a level surface.
Set drain pan under the oil pan and in line with
drain plug (Fig. 28).
Clean area around drain plug.
Remove oil drain plug and allow oil to flow into
drain pan.
&%/,#
&( ", &) +(/%
Remove and replace oil filter (Fig. 29); refer to parts
catalog for part number.
&%/,#
&( $&(.#,
&+-.&!'
After oil is drained, reinstall drain plug and wipe up
any oil that is spilled.
Fill crankcase with oil; refer to Check Engine Oil.
/#( )'
Drain and clean fuel if tank becomes contaminated or
machine is to be stored for an extended period. Use
clean solvent to flush out the tank.
/#( &)#- )" *))#!.&*)-
Check lines and connections every 400 hours or yearly,
whichever comes first. Inspect for deterioration,
damage or loose connections.
/#( &(.#,
Replace the fuel filter after every 200 hours or yearly,
whichever comes first.
Clamp both fuel lines that connect to fuel filter
(Fig. 30) so gasoline cannot drain when lines are
removed.
Loosen hose clamps (Fig. 30) at each end of filter,
pull fuel lines off and discard filter.