Toro 30072, Руководство оператора, Страница: 16 / 44

2. To engage blade, squeeze blade control bail against
the upper control bar (Figure 12).
3. Pull the blade control switch (PTO) up and release.
Hold the blade control bail against the upper
control bar while operating.
4. Repeat the procedure to engage the mower blades if
the blade control bail is released.
Figure 12
1. Upper control bar 3. Power take off switch
(PTO)
2. Blade control bail
Disengaging the Mower Blades (PTO)
Release the blade control bail to disengage the blades
(Figure 12).
The Safety Interlock System
CAUTION
If safety interlock switches are disconnected or
damaged the machine could operate unexpectedly
causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock switches
daily and replace any damaged switches before
operating the machine.
Understanding the Safety Interlock
System
The safety interlock system is designed to prevent the
mower blades from rotating unless:
• The control bail is depressed.
• The blade control switch (PTO) is pulled on .
The safety interlock system is designed to stop the
mower blades if you release the blade control bail.
Testing the Safety Interlock System
Service Interval: Before each use or daily
Test the safety interlock system before you use the
machine each time.
Note:
If the safety system does not operate as
described below, have an Authorized Service Dealer
repair the safety system immediately.
1. Set the parking brake and start the engine;
refer to Starting and Stopping the Engine in
Operation (page 13).
2. Squeeze the blade control bail against upper control
bar. The blades should not rotate.
3. Then continue holding the blade control bail and
pull up on the blade control switch and release. The
clutch should engage and the mower blades begin
rotating.
4. Release the blade control bail. The blades should
stop rotating.
5. With the engine running, pull up the blade control
switch (PTO) and release without holding the blade
control bail.
The blades should not rotate.
Driving Forward or Backward
The throttle control regulates the engine speed as
measured in RPM (revolutions per minute). Place the
throttle control in the
fast position for best mowing
performance.
Driving Forward
1. To go forward, move the shift lever to a forward
gear (Figure 13).
2. Release the parking brake; refer to Releasing the
Parking Brake in Brake Maintenance (page 30).
3. Slowly press on the upper control bar to move
forward (Figure 13).
To go straight, apply equal pressure to both ends of
the upper control bar (Figure 13).
To turn, release pressure on the upper control bar
side in the direction you want to turn (Figure 13).
16