Toro 30072, Руководство оператора, Страница: 11 / 44

between top and bottom of the shift lever should
be equal (Figure 5).
2. If clearance is not correct, remove lever and bend it
slightly to adjust (Figure 5).
Note:
Do not bend lever while it is attached to the
transmission shaft or damage may occur.
Figure 5
1. Shift lever 4. Square hole washer
2. Shift lever plate 5. Spring washer
3. Rubber seal washer 6. Locknut, (3/8 inch)
3. Shift lever to neutral and check alignment of lever in
slot of shift lever plate. The clearance on the sides of
shift lever should be equal (Figure 5).
4. If clearance is not correct, loosen shift lever plate and
adjust it side-to-side. Tighten the shift lever plate.
Note:
Tighten left side of the fuel tank until it is
completely tight and then unscrew locknut one full
turn. This will allow the spring to work.
Figure 6
1. Shift lever in 2nd gear 3. Shift lever in neutral
position
2. Shift lever plate 4. Equal distance
3
Reading the Manual and
Viewing the Training Material
Parts needed for this procedure:
1 Operator’s Manual
1 Engine Operator’s Manual
1 Training material
1 Registration Card
Procedure
• Read the Operator’s Manual.
• View the training material.
• Fill out the registration card and mail it in or register
online at www.Toro.com.
• Use the oil drain hose when changing the engine oil.
11