
Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
Maintenance Procedure
After the first 8 hours
• Change the engine oil.
After the first 50 hours
• Check and adjust the track tension.
Before each use or daily
• Check the engine oil level.
• Grease the machine. (Grease immediately after every washing.)
• Check the engine oil level.
• Check the condition of and clean the tracks.
• Check the condition of the teeth and rotate or replace any that are worn or damaged.
• Remove debris from the machine.
• Check for loose fasteners.
Every 25 hours
• Check the hydraulic fluid level.
• Check the battery electrolyte level.
Every 100 hours
• Change the engine oil.
• Check the spark plugs.
• Check and adjust the track tension.
• Check the hydraulic lines for leaks, loose fittings, kinked lines, loose mounting
supports, wear, weather, and chemical deterioration and repair if necessary.
Every 200 hours
• Change the oil filter.
• Replace the fuel filter.
• Replace the hydraulic filter.
Every 250 hours
• Replace the primary air filter and check the condtion of the safety filter
• Check and grease the road wheels.
Every 400 hours
• Change the hydraulic fluid.
Every 1,500 hours
• Replace all moving hydraulic hoses.
Yearly or before storage
• Check and adjust the track tension.
• Touch up chipped paint
Important:
Refer to your
Engine Operator's Manual
for additional maintenance procedures.
CAUTION
If you leave the key in the ignition switch, someone could accidently start the engine and seriously injure
you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does not accidentally contact the spark plug.
Premaintenance
Procedures
Before opening any of the covers, stop the engine,
remove the key, and allow the engine to cool.
Important:
The fasteners on the covers of this
machine are designed to remain on the cover after
removal . Loosen all of the fasteners on each cover a
few turns so that the cover is loose but still attached,
then go back and loosen them until the cover
comes free. This will prevent you from accidentally
stripping the bolts free of the retainers.
21
Содержание 23210
Страница 41: ...Schematics g013418 Electrical Schematic Rev A 41 ...
Страница 42: ...g013419 Hydraulic Schematic Rev A 42 ...
Страница 43: ...Notes 43 ...