Toro 23210, Руководство оператора, Страница: 11 / 44

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Grinder control lever 1
1
Jam nut 1
Install the grinder control lever.
2
No parts required
–
Check the fluid levels.
3
No parts required
–
Charge the battery.
1
Installing the Grinder Control
Lever
Parts needed for this procedure:
1 Grinder control lever
1 Jam nut
Procedure
1. Thread the jam nut onto the grinder control lever
(Figure 4).
Figure 4
1. Grinder control lever 3. 4-pin connector
2. Jam nut
2. Thread the grinder control lever into the recepticle
on the control panel (Figure 4).
3. With the trigger oriented forward, tighten the jam
nut against the receptacle to secure the lever in place
(Figure 4).
4. Connect the wire on the lever to the 4-pin connector
under the control panel (Figure 4).
2
Checking Fluid Levels
No Parts Required
Procedure
Before starting the engine for the first time, check
the engine oil and hydraulic fluid levels; refer to
Checking the Engine Oil Level (page 16) and
Checking the Hydraulic Fluid Level (page 16) for more
information.
3
Charging the Battery
No Parts Required
Procedure
Charge the battery; refer to
Charging the Battery (page 29) for more information.
11