Toro 23210, Руководство оператора, Страница: 18 / 44

3. Turn the key off (Figure 20).
Note:
If the engine has been working hard or
is hot, let it idle for a minute before turning the
ignition key off. This helps cool the engine before
it is stopped. In an emergency, the engine may be
stopped immediately.
4. Remove the key.
Stopping the Machine
To stop the machine, release the traction control, move
the throttle lever to slow (turtle), lower the grinder to
the ground, stop the engine, and remove the key.
CAUTION
A child or untrained bystander could attempt to
operate the machine and be injured.
Remove the key from the switch when leaving the
machine, even if just for a few seconds.
Moving a Non-functioning
Machine
Important:
Do not tow or pull the machine
without first opening the tow valves, or the
hydraulic system will be damaged.
1. Stop the engine.
2. Remove the bottom shield.
3. Using a wrench, turn the tow valves on the hydraulic
motors twice counter-clockwise (Figure 21).
Figure 21
1. Tow valves
4. Install the bottom shield and tow the machine as
required.
5. When the machine has been repaired, close the tow
valves before operating it.
Grinding a Stump
DANGER
The grinder will cut and amputate hands and feet.
• Stay in the operator's position while the grinder
is running and keep away from the grinder.
• Keep all bystanders a safe distance from the
grinder.
• Stop the grinder immediately if any people or
animals enter the work area.
WARNING
Grinding a stump will throw wood chips, soil, and
other debris into the air which could injure you or
bystanders.
• Always wear eye protection when using the
grinder.
• Keep all bystanders a safe distance from the
grinder.
WARNING
The grinder is very loud when cutting a stump and
can damage your ears.
Always wear hearing protection when using the
grinder.
1. Start the engine, raise the grinder, set the throttle
lever to the Fast position, and move the machine to
the stump to be ground.
2. Use the grinder control lever and the traction
control to position the grinder to one side of the
front of the stump, about an inch below the surface
(Figure 22).
18