Toro 137-1019, Руководство по установке

Страница: 13 / 24

10
Installing the Cab Mount
Brackets
Parts needed for this procedure:
1 Left mount assembly
1 Right mount assembly
2 Adjuster bolt (3/8 x 2 inches)
2 Hex nut (3/8 inch)
4 Hex-flange head bolt (3/8 x 1 inch)
4 Flange nut (3/8 inch)
2 Front cab mount bracket
2 Hex-head bolt (7/16 inch)
2 Thrust washer
2 Locknut (1/2 inch)
2 Rubber isolator
2 Spacer
2 Washer
2 Locknut
2 Flange-head bolt (1/2 x 2-1/4 inches)
Procedure
1. Install the rear brackets on the machine ( Figure
41 ) using the previously removed hardware.
g026243
Figure 41
2. Torque the bolts to 94 to 108 N∙m (70 to 80 ft-lb).
3. Install the left mount assembly and right mount
assembly to the front cab mount brackets using
2 hex-flange head bolts (3/8 x 1 inch) and 2
flange nuts (3/8 inch) on each side (
Figure 42 ).
Use the center holes in the mount assembly
when installing.
4. Install the adjuster bolt (3/8 x 2 inches) and
hex nut (3/8 inch) into the left mount assembly
and right mount assembly on each side of the
machine (
Figure 42 ).
g245967
Figure 42
1. Flange nuts (3/8 inch) 5. Hex-flange head bolts (3/8
x 1 inch)
2. Front cab mount bracket 6. Adjuster bolt (3/8 x 2
inches)
3. Center holes 7. Hex nut (3/8 inch)
4. Left mount assembly
5. Install the front cab mount brackets using a
hex-head bolt (7/16 inch), thrust washer, and
locknut (1/2 inch) on each side (
Figure 43 ).
g245966
Figure 43
1. Hex-head bolt (7/16 inch) 3. Locknut (1/2 inch)
2. Thrust washer 4. Front cab mount bracket
6. Install the 2 rubber isolators using a flange-head
bolt (1/2 x 2-1/4 inches), spacer, washer, and
locknut on each side (
Figure 44 ).
13