Toro 132-4193, Руководство по установке

Страница: 4 / 16

Figure 4
1. Measure here 3. Bolt
2. Nut 4. Hydraulic cylinder
5. Disconnect the hydraulic cylinder (Box B of Figure 4 ).
6. Remove the pillow-bearing assembly (Box C of Figure
4 ).
Note:
Discard the washer but keep the bolts and nuts.
7. Support the rod-loader assembly ( Figure 1 ).
8. Remove the hardware securing the cam assembly to the
machine (Box D of
Figure 4 ).
9. Remove the cam assembly ( Figure 2 ).
10. Remove the wear pads and hardware connected to the
cam assembly as shown in
Figure 5 .
Figure 5
11. Assemble the new cam assembly using the wear pads
and bolts from the previous cam assembly and 14
flange nuts and 2 locknuts (M8) included in this kit
(
Figure 5 ).
12. Install the new cam assembly using the 3 bolts (M10-1.5
x 30 mm), 1 bolt (M10-1.5 x 35 mm), and 1 locknut
(M10) as shown in
Figure 6 .
Figure 6
1. Bolt (M10-1.5 x 35 mm)
and locknut (M10) 2. Bolts (M10-1.5 x 30 mm)
13. Connect the hydraulic fitting disconnected in step 3
( Figure 3 ).
14. Install the hydraulic cylinder assembly using the bottom
bolt from the previous cam assembly and 1 flange nut
from this kit as shown in
Figure 7 .
Figure 7
1. Flange nut
15. Torque the M10 bolts to 47 to 57 N-m (34 to 42 ft-lb).
16. Discard the washer that was removed during the
removal of the cam assembly in step
6 ; refer to Box C
of Figure 4 and Figure 8 .
4