Toro 132-4193, Руководство по установке

Страница: 2 / 16

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Rotary sensor 1
Inner sensor bracket 1
Outer sensor bracket 1
Bolt (M4-10 mm) 2
Bolt (M8-1.25 x 20 mm) 2
Locknut (M8) 4
Cam assembly 1
Flange nut 15
Bolt (M10-1.5 x 30 mm)
3
Bolt (M10-1.5 x 35 mm) 1
Locknut (M10) 1
Nut (M10-1 mm) 1
Nut (M4-0.07 mm) 2
1
Flat washer 2
Install the rotary sensor.
Bolt (M8-1.25 x 40 mm) 2
Bolt (M8-1.25 x 30 mm)
2
Bolt (M5-0.08 x 25 mm) 2
Nut (M5-0.08 mm) 2
2
Bolt (M8-1.25 x 20 mm) 2
Move the proximity sensor and replace
the adjustment hardware.
Wiring harness 1
3
Cable ties 16
Install the wiring harness.
4
Gasket 1
Remove the rotary pump supply and
drain orifices.
Adjustment block 4
Brace 4
Nut (3/8-16 inch) 8
Bolt (3/8-16 x 1 1/4 inch) 4
Bolt (3/8-16 x 1 inch) 4
Spacer 8
Washer 8
5
Bolt (M12-1 3/4 x 70 mm) 8
Install the thrust motor anti-rotation
supports.
Bracket 1
Plate flag 1
Bolt (M5-0.08 x 25mm) 4
Nut (M5) 4
6
Cable tie 2
Install the proximity switch bracket.
Valve cap 1
Monitor cap 1
7
Decal 1
Install the caps and decal.
Park the machine on a level surface, turn off the engine, and remove the key.
2