Toro 111-8083, Инструкция по установке

Страница: 3 / 4

1
2
G028950
Figure 5
1. Cable tie 2. Blanking cap
5. Remove the 1/4-inch hose from the tee on the lift
cylinder for the right, rear cutting-unit (
Figure 6 ).
1
G028951
Figure 6
1. 1/4-inch hose
6. Attach the new 1/4-inch hose to the lift cylinder
(
Figure 6 ).
7. Loosen the cable ties and fitting on the center-back
cutting-unit drain-hose.
8. Attach the 3/8-inch hose from the front tee assembly
to the bottom of the rear tee assembly (
Figure 4 ).
9. Attach the end of the 1/4-inch hose from the center,
rear cutting-unit to the rear tee assembly (
Figure 4 ).
10. Attach the end of the new 1/4-inch hose from the right,
rear cutting-unit to the rear tee assembly (
Figure 4 ).
11. Attach the straight end of the new 3/8-inch hose to the
top of the rear tee assembly (
Figure 4 ).
12. Tighten all the fittings and the previously loosened
cable ties.
3
Installing the Filler Plate
Assembly
Parts needed for this procedure:
1 Filler plate
1 3/8-inch bulkhead fitting
1 Cable tie
Procedure
1. Remove the old filler plate assembly from the top of
the tank.
2. Remove the filler cap assembly from the old filler plate
and install it on the new filler plate.
Note:
For ease of installation, orient the filler plate so
that the small hole is in the lower right corner ( Figure
7 ).
1 2
3
G028958
Figure 7
1. 3/8-inch hose 3. Filler cap
2. Bulkhead fitting
3. Insert the 3/8-inch bulkhead fitting into the filler plate
with the long leg into the tank (
Figure 7 ).
4. Attach the new filler plate assembly to the top of the
oil tank using the hardware from the old filler plate.
Note:
Ensure that the bulkhead fitting is on the right
when viewed from the rear of the machine.
5. Route the 3/8-inch hose from the rear tee assembly
up the right side of the return filter and connect it to
the bulkhead fitting.
6. Secure the hose to the rear manifold near the return
filter using a cable tie.
3