1
2
G024527
Figure 5
1.
Top plate facing forward
(center assembly)
2.
Top plate facing backward
(side assembly)
2.
Insert a long spacer into the pivot hole of each side
assembly (Figure 6).
2
1
3
4
5
6
G024501
Figure 6
1.
Center assembly
4.
Side assembly
2.
Cable guard
5.
Long spacer
3.
Locknut (3/4 inch)
6.
Bolt (3/4 x 3-1/2 inches)
3.
Align the pivot hole in the right-side assembly to the
pivot hole on the right-hand side of the center assembly.
4.
Align a cable guard over the pivot hole, and secure
them with a bolt (3/4 x 3-1/2 inches) and a locknut
(3/4 inch), torqued to 163 to 217 N-m (120 to 160
ft-lb); refer to Figure 6.
Note:
Ensure that the side assembly pivots freely.
Slightly loosen the nut and bolt if necessary. Ensure
that the carriage bolts do not contact each other
throughout the range of motion.
5.
Align the pivot hole in the left-side assembly to the
pivot hole on the left-hand side of the center assembly.
6.
Align a cable guard over the pivot hole, and secure
them with a bolt (3/4 x 3-1/2 inches) and a locknut
(3/4 inch), torqued to 163 to 217 N-m (120 to 160
ft-lb); refer to Figure 6.
Note:
Ensure that the side assembly pivots freely.
Slightly loosen the nut and bolt if necessary. Ensure
that the carriage bolts do not contact each other
throughout the range of motion.
4
Connecting the Drawbar to the
Rake
Parts needed for this procedure:
1
Drawbar
1
Bolt (3/4 x 3-1/2 inches)
1
Locknut (3/4 inch)
1
Long spacer
Procedure
1.
Insert a long spacer into the hole in the rear of the
drawbar (Figure 7).
1
2
3
4
5
G024505
Figure 7
1.
Pivot assembly
4.
Long spacer
2.
Locknut (3/4 inch)
5.
Drawbar
3.
Bolt (3/4 x 3-1/2 inches)
2.
Align the hole in the rear of the drawbar with the hole
in the pivot assembly.
5
