Toro 08712, Руководство оператора

Страница: 4 / 24

g003662
Figure 3
1. Center shroud
3
Preparing to Install the
Hydraulic Components
No Parts Required
Procedure
1. Locate the hydraulic tube that goes from the oil
cooler to the existing lift valve (
Figure 4 ).
2. Remove the fasteners and tube clamp securing
the hydraulic tubes to the frame.
3. Disconnect and remove the hydraulic tube from
the oil cooler and the lift valve (
Figure 4 and
Figure 6 ).
Note:
You may discard this hydraulic tube.
Note:
To minimize oil loss when removing
the hydraulic tube, have the replacement hose
ready or cap the fitting on the cooler using one of
the protective shipping caps removed from the
tube assembly, Part No. 108-8447 (
Figure 19 ).
g003671
Figure 4
1. Oil cooler
2. Hydraulic tube
4. Secure the remaining hydraulic tube to the
frame with the clamp and fasteners previously
removed.
4