Toro 08712, Руководство оператора

Страница: 11 / 24

9
Installing the Hydraulic
Hoses
Model 08705 Only
Parts needed for this procedure:
1 Tube assembly
1 Hydraulic hose (Part No. 108-8449)
1 Hydraulic hose (Part No. 108-8453)
1
Hydraulic hose (Part No. 108-8454)
1 Wire hose holder
2 Thread forming screw (5/16 x 3/4 inch)
3 Plastic cable tie
Procedure
1. Connect the tube assembly (Part No. 108-8447)
to the 90° fitting on the left side of the new valve
and the vacated fitting on the existing lift valve
(
Figure 19 ).
2. Connect the 45° fitting end of hydraulic hose
(Part No. 108-8449) to the 90° fitting on the right
side of the valve and the straight end of the hose
to the vacant oil cooler fitting (
Figure 19 ). Refer
to Figure 20 and Figure 21 for hose routing.
3. Mount the wire hose holder to the left frame tube
with 2 thread-forming screws (5/16 x 3/4 inch);
refer to
Figure 19 .
4. Connect the short 90° fitting end of hydraulic
hose (Part No. 108-8453) to the top straight
fitting on the rear of the valve. Route the hose
through the wire hose holder and connect the
straight end of the hose to the top hydraulic
cylinder fitting (
Figure 19 ). Refer to Figure 20
and Figure 21 for hose routing.
5. Connect the long 90° fitting end of the hydraulic
hose (Part No. 108-8454) to the bottom straight
fitting on the rear of the valve. Route the hose
through the wire hose holder and connect the
straight end of the hose to the bottom hydraulic
cylinder fitting (
Figure 19 ). Refer to Figure 20
and Figure 21 for hose routing.
Important:
Ensure that the hoses are
routed away from any sharp, hot, or moving
components.
6. Tighten all fasteners and fittings.
7. Using cable ties, secure the hoses to the
machine at the locations shown in
Figure 20 and
Figure 21 .
g003672
Figure 19
Model 08705
1. New valve 3. Existing valve 5. Wire hose holder 7. Hydraulic hose (Part No.
108-8454)
2. Tube assembly (Part No.
108-8447) 4. Hydraulic hose (Part No.
108-8449) 6. Hydraulic hose (Part No.
108-8453)
11