Toro 07385 Workman HDX-D, Руководство оператора

Страница: 16 / 60

Hour Meter
Indicates the total hours of machine operation. The hour
meter (
Figure 8 ) starts to function whenever the key switch is
rotated to the On position or if the engine is running.
3rd High Lockout Switch
Move the 3rd-high-lockout switch ( Figure 8 ) to the slow
position and remove the key to prevent the use of third gear
when in the High range. The engine will shut off if the shift
lever is moved to third gear when in High range. The key is
removable in either position.
Light Switch
Push the light switch ( Figure 8 ) to toggle the headlights on
or off.
Oil Pressure Warning Light
The oil pressure warning light glows ( Figure 8 ) if the
engine-oil pressure drops below a safe level while the engine
is running. If the light flickers or remains on, stop the vehicle,
turn off the engine, and check the oil level. If the oil level is
low, but adding oil does not cause the light to go out when
the engine is restarted, turn the engine off immediately and
contact your local Toro distributor for assistance.
Check the operation of warning lights as follows:
1. Apply the parking brake.
2. Turn the starter key to the On/Preheat position, but
do not start the engine.
Note:
The oil pressure light should glow red. If the
light does not function, either a bulb is burned out or
there is a malfunction in the system which must be
repaired.
Note:
If engine was just turned off, it may take 1 to
2 minutes for the light to come on.
Glow-plug Indicator
The glow-plug indicator ( Figure 8 ) will glow red when the
glow plugs are activated.
Important:
The glow plug indicator will turn on, for an
additional 15 seconds, when the switch returns to the
Start position.
Coolant-temperature Gauge and Light
Registers the coolant temperature of the engine. Operates
only when the starter switch is in On position (
Figure 8 ).
The indicator light will illuminate blinking red if the engine
overheats.
Charge Indicator
Illuminates when battery is being discharged. If the light
illuminates during operation, stop the machine, turn off the
engine, and check for possible causes, such as the alternator
belt (
Figure 8 ).
Important:
If the alternator belt is loose or broken, do
not operate the machine until adjustment or repair is
complete. Failure to observe this precaution may result
in damage to the engine.
Check the operation of warning lights as follows:
•
Apply the parking brake.
•
Turn the starter key to the On/Preheat position, but do
not start the engine. The coolant temperature, charge
indicator, and oil-pressure lights should glow. If any light
does not function, either a bulb is burned out or there is a
malfunction in the system which must be repaired.
Fuel Gauge
The fuel gauge shows the amount of fuel in the tank. It
operates only when starter switch is in the On/Preheat
position (
Figure 8 ). Red indicates low fuel level and blinking
red indicates near empty.
High-flow Hydraulics Switch (TC
models only)
Turn on the switch to activate the high-flow hydraulics
(
Figure 8 ).
Horn Button (TC models only)
Pressing the horn button activates the horn ( Figure 8 ).
Tachometer
The tachometer registers the speed of the engine ( Figure 8
and Figure 9 ). White triangle indicates the desired rpm for
PTO operation ( Figure 9 ).
Figure 9
1. Speed of the engine 2. 3,300 rpm for 540 rpm
PTO operation
16