3
Assembling the Latch Pins
Parts needed for this procedure:
2
Hex nut (7/16 inch)
2
Latch pin
2
Latch-pin cam
4
Thrust washer
2
Pin guard
Procedure
1.
Align the latch-pin cam with the opening at the striker
plate in the position shown in Figure 5.
Figure 5
1.
Hex nut (7/16 inch)
4.
Thrust washer
2.
Striker plate
5.
Latch pin
3.
Latch-pin cam
6.
Pin guard
2.
Insert the latch pin (without the washers at first) into
the latch-pin cam (Figure 5).
Note:
If the latch pin is not centered in the door latch,
add 1 or 2 of the thrust washers.
3.
Align the pin guard and the hex nut (7/16 inch) onto
the back side of the opening at the strike plate (Figure
5).
4.
Tighten the hex nut (7/16 inch) onto the latch pin, so
it is finger tight (Figure 5).
4
Assembling the Door Lanyards
Parts needed for this procedure:
2
Lanyard
4
Shoulder bolt (5/16 x 1/2 inch)
4
Locknut (5/16 inch)
Procedure
1.
Assemble the lanyard to the door-frame hinge with a
shoulder bolt (5/16 x 1/2 inch) and a locknut (5/16
inch) as shown in Figure 6.
Figure 6
1.
Lanyard
3.
Locknut (5/16 inch)
2.
Shoulder bolt (5/16 x 1/2
inch)
4.
Door-frame hinge
2.
Assemble the other end of the lanyard to the cab frame
forward-strut-bracket hole with a shoulder bolt (5/16
x 1/2 inch) and a locknut (5/16 inch) as shown in
Figure 7.
Figure 7
1.
Locknut (5/16 inch)
3.
Lanyard
2.
Bracket
4.
Shoulder bolt (5/16 x 1/2
inch)
3
