
6
Installing the Side Panels
Parts needed for this procedure:
2
Side-plate panels
4
Bolts (1/4 inch)
2
Side-plate foam panel
Installing the Side-Plate Panels
1.
Fasten the mounting plates onto the cab using 4
bolts (1/4 inch) as shown in
.
2.
Torque the bolts to 1017 to 1243 N∙cm (90 to
110 in-lb).
3.
Remove the paper backing from the double stick
tape on the mounting plates (
g026279
Figure 6
1.
Foam panel
3.
Bolts (1/4 inch)
2.
Mounting plates
4.
Double-stick tape
4.
Install the foam panels onto the assembly
(
).
7
Installing the Seat Belts
Parts needed for this procedure:
2
Seat-belt anchors
4
Bolts (3/8 x 3/4 inch)
4
Nuts (3/8 inch)
2
Seat belt receiver end
4
Bolt (7/16 inch)
4
Nut (7/16 inch)
2
Seat-belt bracket
2
Seat belts
2
Bolt (3/8 x 7/8 inch)
Installing the Seat Belts
1.
Mount a seat belt bracket to each ROPS tab
with 2 bolts (3/8 inch) as shown in
g026673
Figure 7
1.
Bolt (7/16 inch)
3.
Nut (7/16 inch)
2.
Bolt (3/8 x 7/8 inch)
2.
Torque the 4 bolts (3/8 inch) to 37 to 45 N∙m (27
to 33 ft-lb).
3.
Mount the retractable end of each seat belt
assembly to each seat belt anchor bracket with
a bolt (7/16 inch) and a nut (7/16 inch) as shown
in
Note:
If your machine was already equipped
with a ROPS assembly, the seat belt anchors
should already be installed; proceed to
the Wire Harness (page 8)
.
4.
Torque the 2 bolts (7/16 inch) to 67 to 83 N∙m
(49 to 61 ft-lb).
6
Содержание 07320
Страница 10: ...Notes...
Страница 11: ...Notes...