Toro 07320, Руководство по установке, Страница: 3 / 12

Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Prepare the machine.
2
No parts required
–
Remove the ROPS assembly.
3
Compression spring
2 Install the compression spring.
Floor mount 2
Nut (3/8 inch) 6
Bolt (3/8 x 1 inch)
4
Bolt (5/16 inch) 2
Nut (5/16 inch) 2
Bolt (3/8 x 7/8 inch) 2
4
Washer 2
Install the floor mounts.
Cab frame 1
Bolts (3/8 x 7/8 inch) 4
Bolt (3/8 x 3/4 inch)
10
5
Nuts (3/8 inch) 10
Install the cab frame.
Side-plate panels 2
Bolts (1/4 inch) 4
6
Side-plate foam panel 2
Install the side panels.
Seat-belt anchors 2
Bolts (3/8 x 3/4 inch) 4
Nuts (3/8 inch) 4
Seat belt receiver end
2
Bolt (7/16 inch) 4
Nut (7/16 inch) 4
Seat-belt bracket 2
Seat belts 2
7
Bolt (3/8 x 7/8 inch) 2
Install the seat shroud.
Wire harness 1
Clip tie
1
Plug 1
8
Fuse (30 A) 1
Route the wire harness.
Media and Additional Parts
Description Qty. Use
12 V Power Plug Adapter Kit 1
This kit is needed for the Workman MDE Utility Vehicle
only.
3