Toro 07213TC, Руководство оператора

Страница: 47 / 55

Figure 57
1. Shift arm (1st—Rev.)
2. Shift arm (2nd—3rd)
3. Shift arm (High—low)
Adjusting Differential Lock Cable
(Fig. 58)
Check adjustment every 200 hours.
1. Move differential lock lever to Off position.
2. Loosen jam nuts securing differential lock cable
to bracket on transaxle.
Figure 58
1. Differential lock cable
2. Transaxle bracket
3. Spring
3. While pulling back on spring, adjust jam nuts to
obtain 0.89mm ± 0.64mm ( 0.035” ± .025”) gap
between spring hook and O. D. of hole in
transaxle lever.
4. Tighten jam nuts after adjustment has been
attained and recheck.
Emergency Box Raising (without
starting the engine)
The box can be raised in an emergency by cranking
the starter and holding the lift lever. Run starter for 15
seconds then wait 60 seconds before engaging starter
again.
If engine will not crank, the load and box (attachment)
must be removed to service engine or transaxle.
Inspect Brakes
Visually inspect brakes for worn brake shoes after
every 600 hours of operation.
Inspect Tires
Check tire condition at least every 100 hours of
operation. Operating accidents, such as hitting curbs,
can damage a tire or rim and also disrupt wheel
alignment, so inspect tire condition after an accident.
Front Wheel Toe-In (Fig. 59–60)
After every 600 operating hours or annually, check
front wheel toe-in.
1. Measure center-to-center distance (at axle height)
at front and rear of steering tires. Front
measurement must be equal to the rear
measurement ±3mm (
1 ⁄
8
in.).
Figure 59
1. Center-to-center distance
2. To adjust, loosen jam nuts at both ends of tie rod.
3
1
2
0.89mm ±0.64mm
3
1
2
47