Toro 07213TC, Руководство оператора

Страница: 14 / 55

2. Secure steering wheel to shaft with jam nut and
tighten it to 14–20 Nm (10–15 ft lb.).
3. Install cap to steering wheel.
Figure 4
1. Steering Wheel
2. Jam Nut
3. Cap
4. Washer
5. Foam Seal
Install Front Fenders (Fig. 5)
1. Mount a fender to each side of skirt with (7) 10-
24 Phillips screws, flat washers and locknuts.
Figure 5
1. Fender
Install the Roll-Over Protection
System (Fig. 6)
1. Insert each side of the system into the mounting
bracket on each side of the vehicle frame,
positioning the protection system as shown in
figure 6.
2. Secure each side of the roll-over protection
system to mounting brackets with (2) 1 ⁄
2
-13 x 3”
lg. capscrews and locknuts.
Figure 6
1. Roll-over protection system
2. Mounting brackets
Activate and Charge the Battery
(Fig. 7 & 8)
If the battery is not filled with electrolyte or activated,
it must be removed from vehicle, filled with
electrolyte and charged. Bulk electrolyte with 1.260
specific gravity can be purchased from a local battery
supply outlet.
1. Loosen knobs securing battery cover to battery
base and slide cover off.
2. Remove capscrew, washers and locknut securing
battery hold down to battery base. Remove hold
FRONT
14
Electrolyte gases are explosive and can cause
serious injury to eyes, lungs and skin. Wear
safety goggles and rubber gloves when working
with electrolyte or battery. Charge the battery in
a well-ventilated place so gasses produced
while charging can dissipate. Since the gases
are explosive, keep open flames and electrical
spark away from the battery; do not smoke.
Nausea may result if the gases are inhaled.
Unplug charger from electrical outlet be fore
connecting to or disconnecting charger leads
from battery posts.
CAUTION