Toro 07213TC, Руководство оператора

Страница: 38 / 55

After maintenance is completed, remove safety
support, slide it onto storage stud and lower bed.
1. Raise bed until lift cylinders are fully extended.
2. Remove bed support from storage brackets on
back of the roll-over protection panel (Fig. 33).
Figure 33
1. Bed support
3. Push bed support onto cylinder rod, making sure
support end tabs rest on end of cylinder barrel and
on cylinder rod end (Fig. 34).
Figure 34
1. Bed support
2. Cylinder barrel
3. Bed
4. To store bed support, remove bed support from
cylinder and insert into brackets on back of the
roll-over protection system.
5. Always install or remove bed support from
outside of bed.
6. Do not try to lower bed with bed safety support
on cylinder.
Jacking the Vehicle (Fig. 35 & 36)
1. Do not start engine while vehicle is on jack,
because engine vibration or wheel movement
could cause vehicle to slip off jack.
2. Do not work under vehicle without jack stands
supporting it. The vehicle could slip off jack,
injuring any one beneath it.
3. The jacking point at the front of the vehicle is
under the front center frame support and at the
rear it is under the axle tube.
4. When jacking up front of vehicle, always place a
5 x 10 cm (2” x 4”) block (or similar material)
between jack and vehicle frame.
1
38
Before servicing or making adjustments to the
machine, stop engine, set parking brake and remove
key from ignition switch. Any load material must be
removed from bed or other attachment before
working under raised bed. Al ways place the safety
support on extended lift cylinder to hold box up.
WARNING