Toro 07142, Руководство оператора, Страница: 14 / 16

For Gasoline/Petrol or EFI
Machines
1. Install the new fuse block as follows:
•
For 2018 and before machines , snap the
new fuse block onto the existing fuse block
on the machine (
Figure 17 ).
•
For 2019 and after machines , secure the
new fuse block using the 2 self-tapping
screws as shown in
Figure 21 .
g290831
Figure 21
1. Self-tapping screw 2. New fuse block
2. Connect the large connector on the new fuse
block to the optional power cable on the existing
fuse block (
Figure 17 ).
3. Route the wire harness behind the cab and
under the seat, and secure the clip on the wire
harness to the side panel (
Figure 19 ).
4. Install the black terminal ring to the ground block
on the machine (
Figure 22 ).
5. Install the red power wire into an empty slot on
the machine fuse block (
Figure 22 ).
Note:
Install an additional fuse block if there
are no remaining slots open in a fuse block.
g278776
Figure 22
1. Cab wire harness 3. Black ground wire with
spade terminal
2. Black ground wire with
terminal ring 4. Red power wire with spade
terminal
6. Connect the remaining wire to the fused wire on
the new fuse block (
Figure 17 ).
7. Lower the bed and connect the battery; refer to
the
Operator’s Manual .
8. Install the previously removed seat base.
14