Setup
1
Installing the Roller
No Parts Required
Procedure
The cutting unit is shipped without a front roller.
Obtain a roller from your authorized Toro dealer and
install it on the cutting unit, as follows:
1.
Remove the plow bolt, washer, and flange nut
securing one of the height-of-cut arms to the
cutting unit side plate (
g275540
Figure 3
1.
Plow bolt
5.
Washer
2.
Roller
6.
Flange nut
3.
Height-of-cut arm
7.
Roller-mounting screw
4.
Adjusting screw
8.
Cutting-unit assembly
2.
Loosen the roller-mounting screws in the
height-of-cut arms.
3.
Slide the roller shaft into the height-of-cut arm
on the opposite end of the cutting unit.
4.
Slide the height-of-cut arm onto the roller shaft.
5.
Loosely secure the roller to the cutting unit with
the height-of-cut arm and fasteners previously
removed.
6.
Center the roller between the height-of-cut arms.
7.
Tighten the roller-mounting screws.
8.
Adjust to the desired height-of-cut and tighten
the height-of-cut arm mounting fasteners.
2
Installing the Cutting Unit
to the Traction Unit
No Parts Required
Procedure
Install the cutting unit to the traction unit; refer to
your traction unit
Operator’s Manual
for installation
instructions.
3
Adjusting the Cutting Unit
No Parts Required
Procedure
1.
Access the cutting unit by lowering the
traction-unit handle to the ground (
g276933
Figure 4
2.
Adjust the bedknife to the reel; refer to
the Bedknife to the Reel (page 8)
.
3.
Adjust the height of cut; refer to
Height of Cut (page 11)
.
4.
Adjust the grass shield; refer to
Grass Shield (page 13)
.
4
