Toro 04823, Руководство оператора

Страница: 14 / 20

Servicing the Bedbar
Only a properly trained mechanic should service the
bedbar and bedknife to prevent damage to the reel,
bedbar, or bedknife. Ideally, take the cutting unit to
your authorized Toro distributor for service. Refer to
the
Service Manual for your traction unit for complete
instructions, special tools, and diagrams for servicing
the bedknife. Should you ever need to remove
or assemble the bedbar yourself, instructions are
provided below, as are the specifications for servicing
the bedknife.
Important:
Always follow the bedknife
procedures detailed in your Service Manual when
servicing the bedknife. Failure to install and grind
the bedknife correctly can lead to damage to the
reel, bedbar, or bedknife.
Removing the Bedbar
1. Turn the bedbar adjusting-screw
counterclockwise to back the bedknife
away from the reel (
Figure 18 ).
g014641
Figure 18
1. Bedbar-adjusting screw 3. Bedbar
2. Spring-tension nut 4. Washer
2. Back out the spring-tension nut until the washer
is no longer tensioned against the bedbar
(
Figure 18 ).
3. On each side of the machine, loosen the locknut
shown in
Figure 19 .
g276147
Figure 19
1. Bedbar bolt 4. Plastic washer
2. Nut 5. Bedbar
3. Steel washer
4. Remove each bedbar bolt, allowing the bedbar
to be pulled downward and removed from the
cutting unit (
Figure 19 ).
Account for the 2 steel washers and 1 plastic
washer on each end of the bedbar (
Figure 19 ).
14