Toro 04823, Руководство оператора

Страница: 12 / 20

bar and the screw will be snug against the
bedknife. This ensures that the height of cut
is identical at both ends of the bedknife.
6. Tighten the nuts to secure the adjustment
enough to remove play from the washer.
7. Verify that the height-of-cut setting is correct;
repeat this procedure if necessary.
•
For a height of cut greater than 8 mm (0.312 inch),
position the traction-unit drum in the H
IGH
position;
refer to your machine Operator’s Manual .
•
For a height of cut greater than 16 mm (0.625
inch), install the High Height-of-Cut Kit. Contact
your authorized Toro distributor to acquire this kit.
Adjusting the Clip Rate
The clip rate is determined by the following machine
settings:
•
Reel speed : The reel speed can be adjusted to
a high or low setting; refer to your traction unit
Operator’s Manual .
•
Reel-drive-pulley position : The reel-drive pulleys
(22-tooth and 24-tooth) can be set in 2 positions:
– H
IGH
position: “A” in Figure 14
– L
OW
position: “B” in Figure 14
Note:
The pulley position is set to the L
OW
position from the factory.
g275969
Figure 14
1. Pulley (24 tooth) 2. Pulley (22 tooth)
To adjust the position of the pulleys, refer to the
following steps:
1. Remove the belt cover to expose the belt ( Figure
15 ).
g275967
Figure 15
1. Reel-drive-assembly
housing 5. Idler-arm bolt
2. Belt 6. Belt cover
3. Idler-arm internal hex 7. Socket-head screw
4. Idler arm
2. Loosen the idler-arm bolt and rotate the idler
arm (
Figure 15 ) to release tension on the belt.
3. Remove the belt ( Figure 15 ).
4. Loosen the nut on each pulley, remove the
pulleys, and use the nuts to install the pulleys in
your desired configuration.
12