
B.
Install the motor by rotating it clockwise so that
the motor flanges clear the screws. Rotate the
motor counterclockwise until the flanges encircle
the screws. Tighten the screws.
6.
Store the rear reel motor on the
Greensmaster 3150,
3200, and 3250
the same as the front reel motors.
7.
Store the rear reel motor on the
Greensmaster 3100
and 3050
as follows:
A.
Use the dimensions shown in
for the
Greensmaster 3100
and
for the
Greensmaster 3050
, to mark the frame.
G010410
1
2
Figure 9
1.
2.2 cm (0.90 inches)
2.
4.1 cm (1.6 inches)
G01041 1
1
2
Figure 10
1.
3.9 cm (1.5 inches)
2.
1.2 cm (0.51 inches)
B.
Insert the splined shaft of the reel motor into the
storage tube on the frame (
1
2
3
4
G028070
Figure 11
1.
Self-tapping screw
3.
Storage tube
2.
Spacer
4.
Reel motor
C.
Using the reel motor flange as a template, position
it as shown in
, drill an 8.75 mm (0.34
inch) diameter hole on the line drawn in step
D.
Position the spacer between the reel motor flange
and the frame while aligning the holes. Secure the
reel motor and spacer to the frame with a self
tapping screw.
8.
Mount the counter weight to the right side of the rear
tri-roller with 2 capscrews and washers.
Installing the Rear Weight
This unit complies with the ANSI B71.4-2012 and EN ISO
5395:2013 when 19.5 kg (43 lb) of calcium chloride ballast is
added to the rear wheel, and it is equipped with a rear weight
kit. Contact your Authorized Toro Distributor for more
information.
Important:
If a puncture occurs in a tire with calcium
chloride, remove the unit from the turf area as quickly
as possible. To prevent possible damage to the turf,
immediately soak the affected area with water.
4