Toro 04495, Руководство оператора, Страница: 3 / 8

1
2
3
4
5
G028065
Figure 5
Greensmaster 3200 Machine shown
1. Ball stud (large diameter) 4. Nylon bushing
2. Ball-joint receiver 5. Pull-link assembly
3. Spacer
1
2
3
4
5
G028066
Figure 6
Greensmaster 3250 Machine shown
1. Ball stud (large diameter) 4. Nylon bushing
2. Ball-joint receiver 5. Pull-link assembly
3. Spacer
C. Mount a pull-link assembly to each end of the
carrier frame with a spacer, washer, and screw
(
Figure 5 or Figure 6 ).
Note:
Make sure that the nylon bushing is in the
pull link.
D. Install a ball stud and lock washer to each end of
the tri-roller (
Figure 5 or Figure 6 ).
E. Adjust the pull links all the way forward and
tighten the jam nut.
F. Slide the sleeve back on each ball joint receiver
and hook them onto the ball studs (
Figure 5 or
Figure 6 ).
4. When mounting the Tri-Roller Kit to the
Greensmaster 3050, 3100 or 3150 traction unit, use
the small diameter ball stud and washer on each end of
the tri-roller (
Figure 7 ). Adjust the links so that they are
forward as far as they will go.
Note:
To avoid tri-roller interference with the
traction pedal linkage, it may be necessary to lower the
tri-rollers when the reels are in the transport position;
refer to Adjusting the Lift Cylinders in the traction unit
Operator’s Manual .
Note:
When mounting the Tri-Roller Kit in the right
front position on the Greensmaster 3200 or 3250
traction unit, remove the counterweight from the left
end of the unit and mount it on the right end. Connect
the motor to the left end.
G010408
1
2
3
Figure 7
1. Pull link assembly 3. Ball stud (small diameter)
2. Ball joint receiver
5. Mount the front reel motors into the storage positions
as follows:
A. Loosen the mounting screws and washers for the
reel motor to each tri-roller. Leave approximately
1 cm (1/2 inch) of threads exposed on each
mounting screw (
Figure 8 ).
1
2
G028068
Figure 8
1. Mounting screws 2. Reel motor
3