Toro 04351 Greensmaster 3050, Руководство оператора

Страница: 30 / 48

30
Servicing the Air Cleaner
Service the air cleaner foam pre-cleaner after every 50
operating hours and the air cleaner cartridge after every 100
operating hours. More frequent cleaning is required when
operating in dusty or dirty conditions.
1.
Release the locking clips and remove the air cleaner
cover (Fig. 35). Clean the cover thoroughly.
1
Figure 35
1. Air cleaner cover
2. Remove the wing nut securing the elements to the air
cleaner body.
3. If the foam element is dirty, remove it from the paper
element (Fig. 36). Clean it thoroughly.
A. Wash the foam element in a solution of liquid soap
and warm water. Squeeze it to remove dirt, but do
not twist it because the foam may tear.
B. Dry it by wrapping it in a clean rag. Squeeze the rag
and foam element dry.
1
2
Figure 36
1. Foam element 2. Paper element
4. When servicing the foam element, check the condition
of the paper element. Clean it by gently tapping it on a
flat surface or replace it if needed.
5. Reinstall the foam element, paper element, and air
cleaner cover.
Important Do not operate the engine without the air
cleaner element because extreme engine wear and damage
will likely result.
Adjusting the Throttle Control
Proper throttle operation is dependent upon proper
adjustment of the throttle control. Before adjusting the
carburetor, ensure that the throttle control is operating
properly.
1. Loosen the cable clamp screw securing the cable to the
engine (Fig. 37).
1
2
3
4
5
6
7
Figure 37
1. Throttle casing clamp
screw
2. Throttle cable
3. Swivel
4. Stop
5. Choke casing clamp
screw
6. Choke cable
7. Choke butterfly
2. Move the remote throttle control lever forward to the
Fast position.
3.
Pull firmly on the throttle cable until the back of the
swivel contacts the stop (Fig. 37).
4. Tighten the cable clamp screw and check the engine
RPM setting.
High Idle: 2850 ± 50 RPM
Low Idle: 1650
±
100 RPM