Toro 03914, Руководство оператора

Страница: 6 / 16

Note:
The washers on the height-of-cut adjusting
bolts must be located on each side of the flange on the
side plate (Figure 7).
13. Tighten the locknut on the height-of-cut adjuster bolt
until the washers contact the side plate flange, then
back off the nut 1/2 turn (Figure 7).
Figure 7
1. Washer 3. Side plate flange
2. Locknut
14. Center the roller between the height-of-cut brackets
and lock it in place with the bolts and locknuts on the
brackets (Figure 6).
15. Using the reel drive shaft tool, remove the splined insert
from the reel motor side of the reel shaft (Figure 8).
Important:
The splined insert on the left-hand
side of the cutting unit has left-hand threads. The
splined insert on the right-hand side of the cutting
unit has right-hand threads.
1
2
G021695
3
4
Figure 8
Reel motor side
1. New (longer) splined insert 3. Old splined insert
2. Add 242 Loctite (Blue)
here 4. Fill with grease here
16. Install the new (longer) splined drive insert to the
reel shaft (Figure 8). Apply 242 Loctite (Blue) to the
threads of the insert prior to installation. Torque it to
115 to 128 N-m (85 to 95 ft-lb).
17. Fill the end of the insert with all-purpose grease (Figure
8).
18. Using the reel drive shaft tool, remove the splined insert
from the groomer drive side of the reel shaft (Figure 9).
G021694
3
1
2
Figure 9
Groomer drive side
1. New (longer) splined drive
insert 3. Old (shorter) splined insert
2. Add 242 Loctite (Blue)
here
19. Install the new (longer) splined drive insert to the
reel shaft (Figure 8). Apply 242 Loctite (Blue) to the
threads of the insert prior to installation. Torque it to
115 to 128 N-m (85 to 95 ft-lb).
20. On the non-drive side of the groomer assembly ,
slide the groomer plate with quick-up lever off the
groomer shaft assembly (Figure 10).
6