Toro 03673 Reelmaster 5410-G, Руководство оператора

Страница: 15 / 48

Figure 15
1. Turf compensation spring 3. Spring rod
2. Hairpin cotter 4. Hex nuts
2. Tighten the hex nuts on the front end of the spring
rod until the compressed length of the spring is 12.7
cm (5 inches) on Reelmaster 5410, 5 inch cutting units
or 15.9 cm (6.25 inches) on Reelmaster 5510, 7 inch
cutting units (
Figure 15 ).
Note:
When operating on rough terrain decrease
the spring length by 12.7 mm (1/2 inch); this slightly
decreases ground following.
6
Using the Cutting Unit
Kickstand
Parts needed for this procedure:
1 Cutting unit kickstand
Procedure
Whenever the cutting unit has to be tipped to expose the
bedknife/reel, prop up the rear of the cutting unit with the
kickstand to make sure the nuts on the back end of the
bedbar adjusting screws are not resting on the work surface
(
Figure 16 ).
Figure 16
1. Cutting unit kickstand
Secure the kickstand to the chain bracket with the snapper
pin (
Figure 17 ).
Figure 17
1. Chain bracket 3. Cutting unit kickstand
2. Snapper pin
15