Toro 03662, Руководство по установке

Страница: 2 / 8

1
Installing the Rear Lift Cylinder
Limit Kit (Ordered Separately)
Parts needed for this procedure:
4 Cylinder collar
4 Bolt
8 Flanged locknut
2 Spacer
2 Stop bracket
4 Carriage bolt
For 7-inch Diameter Reels
Note:
The Rear Lift Cylinder Limit Kit (Toro part no.
110–9604) is ordered separately. Contact an Authorized Toro
Dealer to order the kit.
1. Position the traction unit on a level surface, lower the
lift arms/cutting units, and stop the machine. Remove
the key from the ignition switch to prevent accidental
starting.
Important:
The Rear Lift Cylinder Limit Kit is
only to be mounted on the #2 and #3 (rear) lift
arm cylinders.
2. Install the cylinder collars to the extended cylinder rod
with 2 bolts and 2 flange locknuts (
Figure 1 ). Make
sure the cylinder collars fit over the top of the cylinder.
3. Loosely install the stop bracket to the deflector bracket
with 2 carriage bolts and 2 locknuts (
Figure 1 ).
4. Move the stop bracket to the highest position on the
bracket and tighten the flange locknuts (
Figure 1 ).
For 5-inch Diameter Reels
Note:
The Rear Lift Cylinder Limit Kit (Toro part no.
110–9604) is ordered separately. Contact an Authorized Toro
Dealer to order the kit.
1. Position the traction unit on a level surface, lower the
lift arms/cutting units, and stop the machine. Remove
the key from the ignition switch to prevent accidental
starting.
Important:
The Rear Lift Cylinder Limit Kit is
only to be mounted on the #2 and #3 (rear) lift
arm cylinders.
2. Install the cylinder collars and the spacer to the
extended cylinder rod with 2 bolts and 2 flange
locknuts (
Figure 1 ). Make sure the cylinder collars fit
over the top of the cylinder and the spacer is flush with
the cylinder end.
3. Loosely install the stop bracket to the deflector bracket
with 2 carriage bolts and 2 locknuts (
Figure 1 ).
4. Move the stop bracket to the lowest position on the
bracket and tighten the flange locknuts (
Figure 1 ).
Figure 1
1. Cylinder collar 5. Stop bracket
2. Spacer 6. Deflector bracket
3. Bolt 7. Carriage bolt
4. Flange locknut
2