1
G025513
2
3
4
5
g025513
Figure 7
1.
Cross fitting (1/4 inch
male)
4.
Bonded seal (1/4 inch)
2.
Elbow (1/4 inch female x
1/4 inch female)
5.
Lift manifold
3.
Adapter (1/4 inch male x
1/4 inch male)
15.
Fasten the lift-control block assembly to the bracket
using 2 bolts (8 x 75 mm), 1 bolt (8 x 65 mm), 6 plain
washers (8 mm), and 3 locknuts (8 mm).
Note:
Some of the solenoids may need to be loosened
or removed to gain access to the bolt holes.
1
G025408
3
3
5
2
4
3
3
g025408
Figure 8
1.
Bolts (8 x 75 mm)
4.
Bolt (8 x 65 mm)
2.
Locknut (8 mm)
5.
Locknuts (8 mm)
3.
Washers (8 mm)
16.
Connect the lift hoses to their relevant connectors on
the lift control block.
Note:
Some hoses will require arranging for neatness.
Where necessary, slacken the hose fittings at each end,
orientate to suit and ensure that both ends of the hose
fittings are tightened.
1
7
G025409
2
3
8
6
5
4
g025409
Figure 9
1.
Hose (1/4 inch x 2.16 m),
to the rotary valve at the
rear of the machine
5.
Hose (existing), to the
center lift cylinder
2.
Hose (existing), to the
front left lift cylinder
6.
Hose (existing), to the left
wing lift cylinder
3.
Hose (existing), to the
front right lift cylinder
7.
Hose (existing), to the
front manifold
4.
Hose (existing), to the right
wing lift cylinder
8.
Hose (3/8 inch x 57.5 cm),
to the lift pump
17.
Referring to
, assemble a line body, a solenoid
valve, and a solenoid. Fit the coupling, the bonded
seal, and the elbow to port 1 of the line body. Fit a
3/8 inch bonded seal, a 3/8 inch male x 3/8 inch
male adapter, two 3/8 inch bonded seals, check valve,
and 3/8 x 1/4 inch male adapter to port 2 of the line
body. Fit the assembly to the tee on the P port of the
lift control block. Fit the hose from the tee to the lift
pump. Fit the hose from the rotary valve at the rear of
the machine to the check valve.
Note:
Ensure that the arrow on the check valve points
away from the line body.
6
