Tornado Floorkeeper 20 OB/99120ORB, Руководство по эксплуатации и техническому обслуживанию

Страница: 12 / 32

12
MACHINE PREPARATION
ATTACHING A CLEANING PAD TO YOUR PAD DRIVER - DISK HEAD
If using a floor pad with your pad driver:
1. Place your pad driver(s) on a work surface and remove the center lock fitting from the pad driver. To do
so on the 20 PD and 20TD, unscrew the center lock in a counter-clockwise motion. To do so on the 24 TD,
squeeze the center lock wires inward and lift the center lock off the pads.
2. Connect the cleaning pad to the disk pad driver by centering it on the driver.
3. For the 20 PD and the 20 TD, screw on the center lock fitting, making sure that the center lock has
compressed the pad and is snug. For the 24TD, Squeeze center lock wires inward and press center lock
down, tab side first, compressing the pad and then release the wires so that they lock in place holding the
pad. Repeat for the other pad driver.
NOTE: The pad drivers are tufted pad drivers. Do not use a pad driver on the floor without a pad in place.
This will cause damage to your floor.
Disconnect center lock fitting & lay next to
the pad driver
20 PD &TD
Center pad on pad driver
20 PD &TD
Screw on center lock fitting
20 PD &TD
MACHINE PREPARATION
ATTACHING YOUR PAD DRIVER OR BRUSH TO THE SCRUBBER - DISK HEAD
The pad driver(s) or brush(es) are attached by using the automatic on/off system. This valuable ingenuity
removes the need for operators to kneel or strain to attach the pad driver or brush.
First, start by placing the pad driver or brush on the floor in front of the scrubber.
1. Turn the unit on using the power key switch.
2. Push or drive it into position so that the unit’s scrub head is centered over the pad driver(s) or brush(es).
3. Utilize the foot pedal to lower the scrub deck down onto the pad driver or brush by depressing the pedal
while shifting it to the right. Once clear of the lower notch, lifting your foot will lower the scrub deck. Make
sure that the shroud completely covers the pad driver(s) or brush(es) in the lowered position. Should
the shroud be resting on a portion of the pad driver or brush, the head isn’t centered and will not attach
properly.
4. The operation is completed by quickly pulsing the activation trigger. This will “click on” the pad driver(s)
or brush(es). If the pad driver(s) or brush(es) do not quickly engage, do not continue pressing the activation
trigger. Realign the scrub deck and try the procedure again. When you have the scrub deck aligned
properly, you should see a noticeable drop of the scrub deck when lowered and the bristle skirt on the
shroud should almost be touching the floor.
Close up showing center lock tab & wires
wires
tab
24 TD
Squeeze center lock wires inward, press
down onto pad & release wires
24 TD
Disconnect center lock fitting & lay next
to the pad driver
24 TD
Center pad on pad driver
24 TD
1
2 3