Getting the most out of your machine
Quickstart Guide
VCSD-01/VCSD-02
Scrubber dryer
VCSD-01/VCSD-02
1) Getting started
2) How to use
Release the handle bar by depressing the handle
release pedal (A).
Turn the machine on and select the
required setting.
A = on/off switch (mains powered
unit only)
B = suction motor on/off switch
C = water flow on/off switch
D = brush motor on/off switch
Disconnect the recovery hose, remove the orange dirty
water tank, plug the charger into the battery then replace
the tank. The unit needs to be plugged in and charged for
4 hours before use until the green LED is displayed.
Fill machine - Pour recommended amount of cleaning
solution into the opening as shown, and top with water
to maximum fill level (max temp of 50°C).
To lift or lower
the squeegee
use the lever
as indicated.
Connect main
isolator key
(battery
version only).
Place scrubber
pad on the floor
and lift pad
holder over the
pad to fix to the
machine.
To activate brushes, pull control
lever towards handle.
Rotate the isolation key on the back
of the unit anti-clockwise to isolate
all power. The key can now be
removed from the unit.
Insert the key and fully rotate
clockwise to provide power for
all functions. The key cannot be
removed in this position.
Open and
adjust the clean
solution water
tap to adjust
flow of water.
Connect the recovery hose located on the back of the
machine to the dirty water tank.
VCSD-01_VCSD-02_QSG_A5_[J1831]_Amd_11.07.13_2.indd 1
11/07/2013 17:03
