19
BRUSHES DISASSEMBLY
With the brushes base in lifted
position (see under paragraph
"BRUSHES ASSEMBLY"),
rotate the brushes sharply in
order to release the button
from the coupling spring until
it becomes free and wash
them with a water jet. The
figure shows the rotating
sense for brushes release.
2. Disassemble the squeegee
(2) from its support (1) by
loosening the knobs (4)
counterclockwise.
3. Clean the internal part of the
squeegee inlet.
4. Clean the squeegee
rubbers.
5. Reassemble all parts paying
attention to put the washers
(3) into position, they are two
for each knob, so that they are
assembled one under and the
other on top on each of the
two slots on the support.
CLEANING OF THE
SOLUTION TANK AND OF
THE OUTER FILTER
1. Bring the machine to an
appropriate place for the
detergent solution draining.
2. Unscrew the solution tank
cap (1).
3. Unscrew the filter cap (2)
and take off the filter. Be
careful not to lose the gasket
of the cap.
4. Unscrew the drain plug of
the detergent solution (3).
5. Rinse the solution tank and
the components of the filter
with a water jet.
6. Reassemble all parts.
BRUSHES CLEANING
Disassemble the brushes and
clean them with a water jet (for
the brushes disassembly see
under paragraph “BRUSHES
DISASSEMBLY”).
ATTENTION:
To carry out brushes
disassembly operations with
the electric supply on, may
cause damages to hands.
SQUEEGEE CLEANING
Keeping the squeegee clean
guarantees the best drying
result.
For cleaning it is necessary to:
1. Take off the squeegee hose
(5) from the coupling.
WEEKLY MAINTENANCE
REAR SQUEEGEE RUBBER
CHECK
Check the squeegee rubber
wear and turn or replace it if
needed.
For the replacement it is
necessary to:
1. Lift the squeegee (see under
paragraph “STOP OF THE
MACHINE AFTER CLEANING
OPERATION”). 2. Unhook the
latches (1).
3. Unscrew the wing nuts (2)
to take off the terminals of the
outer rubber holder blades (3)
and then take off the central
rubber holder blade (4).
4. Take off the rubber (5), turn
it to a new side or replace it.
To reassemble the squeegee
reverse the operations.
SQUEEGEE HOSE CLEANING
Weekly or in case of
insufficient suction, it is
necessary to check that
the squeegee hose is not
obstructed. To clean it,
proceed as follows:
1. Take off the hose (1) from
the squeegee coupling.
2. Wash the inside of the hose
with a water jet.
3. To reassemble the hose
reverse the operations.
