Tornado 2-100 H Professional, Руководство по эксплуатации и техническому обслуживанию

Страница: 5 / 24

Electrical
•
Do not pull your machine by, close a door on, or run over the cord, and keep it away from heated
surfaces.
•
Do not pull on the cord to unplug the machine.
•
Turn all machine switches to OFF before unplugging.
•
Connect to a properly grounded outlet only.
Operational Instructions
•
Use only a (20 amp) electrical outlet, usually found In Bathroom, Kitchens, or Laundry rooms. Plug
your machine in.
•
Attach vacuum and solution hoses to appropriate connections on the machine and your wand. As
you do this, always Inspect hoses for cracks or fraying. Do not use if hoses are cracked or frayed.
•
Mix water and approved extractor detergent in the solution tank at the front of the machine. Use a
clean hose to fill the solution tank. If a hose is not available, use a clean bucket. DO NOT
OVERFILL.
Machine Maintenance
1. Regular dally maintenance Is required to keep this equipment In the best working condition. A
detailed list of preventative maintenance is outlined below. Thoroughly clean all equipment and
accessories after each use:
•
Rinse solution and vacuum recovery tank with clean water.
•
Flush entire pumping system with clean water. This includes all solution hoses and wand(s).
Do not allow liquids to remain in equipment after use.
•
Clean all filters and dump valve.
2. The solution system has one filter located in the solution tank, and high-pressure machines
(200psi and higher) have an in-line filter in the pump compartment. Check filters dally and clean
when dirty in order for them to properly filter debris from the solution tank. If the filter Is missing or
becomes damaged It must be replaced before the machine Is used.
3. Lubricate all quick disconnects with a quality silicone lubricant.
4. Do not use the same pail to fill the solution tank that is used to empty the waste tank. This would
introduce dirt and debris into the solution lines, block the fitters, orifices, and generally degrade
the pumping system.
Winterizing Your Extractor
This unit should be winterized between uses if it is to be exposed to freezing temperatures. To
winterize your machine, pour a 50/50 mix of anti-freeze and water into the empty solution tank. Aim
the spray gun into the solution tank. Run the pump and spray the gun into the solution tank until the
fluid flows
from the gun into the tank.
Serial #'s
The serial number is located on the back of the machine just above the dump valve.