Art.-Nr. 11502 00
- 4 -
TORNADO FLOOR FINISHING MACHINE
PREPARATION FOR USE
1. Assembly (consult assembly drawing step1
～
9)
Press both sides of screw box inwards and pull it out; take out screw by impact. Align the mounting hole of control handle
with the mounting hole of chassis, install the screw and tighten the nut; Put screw box into on chassis.
2. Install pad holder or brush (consult assembly drawing step10)
Keep pad holder or brush flat on the floor, take hold of chassis and lift machine with both hands, align brush holder pad
with pad holder or brush, push chassis hard, make pad holder or brush level and place it properly.
3. Remove pad holder or brush (consult assembly drawing step12)
Lay the machine on its back with the handle lying on the floor; Turn over chassis backward and shown pad holder or brush,
remove pad holder or brush on the brush holder pad.
4. The motion of machine (consult assembly drawing step13
～
14)
Rotate the handle to the highest point, insert the pin in the special-purpose hole of motion, hold tight handle and makes the
two wheels drop to the ground, than can push or pull the machine to move.
CAUTION:
1).Unplug the pin in the special-purpose hole of motion(consult assembly drawing step13),insert the pin to the
working hole(consult assembly drawing step15).
2). The voltage must concur with that given on the machines data plate.
OPERATING INSTRUCTIONS
1.
Before plugged in, must assemble pad holder or brush.
2.
Make sure that the switch is in the OFF (0) position before you plug the electric cord into the outlet, so as not to cause the
danger.
3.
Must keeping the handle on the highest point, prevent the handle from dropping; cause the danger that people or anything.
4.
Unplug the pin in the special-purpose hole of motion, only suitable for the moving machine.
5.
Always wear shoes when using the appliance.
6.
When not in use, remove pad holder or brush, avoid the pad holder or brush being warped.
PURPOSE AND SPECIFICATIONS
TORNADO
floor Machine design for residential use and the main purpose are strip, wash, buff, sand, refinish and dry clean
your carpets.
Specifications of machine:
MOTOR
: induction type motor (no carbon brushes to wear out)
220-240V AC, 50HZ, 1400RPM
SWITCH:
Rocker type, 16 amps, 250V
～
T125
CABLE
: 6meter, 3G0.75mm
2
NET WEIGHT
: 32.56 lbs
SPEED
: 150RPM with additional motion due to brush holder pad design
BRUSH DIA.
: 13 inches - extra coverage due to brush holder pad design
HEIGHT WITH BRUSH
: 41.30 inches
OPERATING
The (ON-OFF) switch is located on the handle. It has been designed to be conveniently activated with your hand. ON (1) –
OFF (0) is printed on the switch.
Be careful that the switch is in the OFF (0) position before you plug the electric cord
into the outlet.
