Attaching the Coolant Trays
32352 Rev 1
8
Tormach® PCNC 1100 Deluxe Stand
We strongly recommend discarding the plastic
washers that come with the tray mounting bolts.
It is best to seal the bolts with silicone caulk only.
Loosely screw 2 bolts in place to hold the tray
while you locate and start the remaining bolts.
Then tighten all bolts.
Next place a double bead of caulk at the joint
between the coolant trays and around the
remaining side of the base as shown in Figure 14.
Repeat the above mounting procedure for the
remaining coolant tray. Apply caulk at each bolt
hole, discard the plastic washers, and loosely bolt
the 2 tray sections together. Start all bolts
before tightening them. Allow the silicone caulk
to cure before removing the excess or using
coolant.
After the coolant trays are installed attach the
stainless steel wear guard across the front of the
chip tray as shown in Figure 15. Parts required are
shown in Figure 16: (14) Stainless Guard Strip; (15)
Stainless Screw (M6×10); (16) Nut (M6); and (17)
Flat Washer.
The final step in the coolant tray installation is to
install the back splash guards. Locate the back
splash guards and test fit them to the coolant
trays as shown in Figure 17.
Figure 13. Apply silicone caulk to each bolt hole.
Figure 14. Double bead of caulk at joint.
Figure 15. Stainless steel wear guard.
