Tormach 1300PL, Руководство оператора

Страница: 60 / 100

8.1 MAINTENANCE SAFETY
Read and understand the following safety messages before
beginning any maintenance procedures.
8.1.1 All Maintenance Procedures
Understand that the machine is automatically controlled
and can start at any time.
Power off the machine and disconnect the pneumatic
supply before doing any maintenance procedures.
When appropriate, lockout/tagout the and the pneumatic
supply line before doing any maintenance procedures.
Wear safety eye protection rated for ANSI Z87+.
8.1.2 Swarf Maintenance Procedures
Wear work gloves.
8.2 MAINTENANCE SCHEDULES
To keep your machine running as smoothly as possible, you
must regularly do the following maintenance procedures.
Note: Before you begin any maintenance procedures,
read and understand "Maintenance Safety" (above).
If you disassemble any components, refer to the machine's
reference drawings when you've completed the maintenance
procedure. For information, see "Diagrams and Parts Lists"
(page 73). For any additional support, we can help. Email
support@tormach.com to contact Tormach Technical Support
for guidance on how to proceed.
8.2.1 Daily
Clean the machine of any dust or abrasive particle
buildup with a vacuum and brushes.
Wipe dust off of the linear rails with a clean cloth.
8.2.2 Weekly
Clean all exterior surfaces with a mild cleaner.
Examine the water table's level and, if necessary, add
water / rust inhibitor.
Check your plasma torch consumables for wear and
replace if needed.
8.2.3 Monthly
Clean the electrical cabinet vents of dust with a clean
cloth or compressed air.
Remove the slats and clean sediment buildup from the
bottom of the water table.
8.2.4 Semi-Annually
Check drive belts for wear and re-tension if needed.
Remove faceplate from torch lifter and clean lead screw
with a lint-free cloth.
8.2.5 As Needed
Replace the water table's slats when they have been
worn away too much to hold stock securely.
8.3 ADJUST BELT TENSION
Tools and Items Required
l
Allen Key Set
The drive belts on the 1300PL should be checked for wear and
tensioned several times a year to avoid lost motion and
reduced machine accuracy.
1. Remove the motor belt cover over the servo motor
pulley.
2. Remove the belt covers from both sides of the gantry.
©Tormach® 2020
Specifications subject to change without notice. Page 60 UM10720: 1300PL Operator's Manual (Version 0820B)
For the most recent version, see tormach.com/support
8: MACHINE MAINTENANCE