3
C3205 PARTS INVENTORY
2 - TIE DOWN RECEIVERS
2 - BENT TIE DOWN INSERTS
2 - 1/4” PINS
THIS KIT USES FACTORY
FASTENERS FOR INSTALLATION
INSTALLATION INSTRUCTIONS
1. Locate and inventory all parts to become familiar with all brackets.
2. Hold the tie down receiver into place to locate the proper pre-existing holes
in the frame at the end of frame rails near the bumper and bottom of frame (
see
photos page A
). Remove the bolt in the side of the frame and remove the bolts
in the bottom of the frame. These bolts will be re-used in the installation of the
tie down.
3. Now place the upper support bracket between the bumper bracket and the
frame and reinstall the two bolts in the bottom of the frame and the one bolt in
the side of the frame. (
See page 3
).
4. Find one insert and 1/4” pin and put the bent insert into the receiver using
the hole in the insert. Install 1/4” pin.
5. You should have at least 1” clearance between the insert and the lip of the
box or after market accessory. Tighten all fasteners. 1/2” bolts to 60 ft.
lbs.(81nm)
***Note: Use locktite on the factory bolts when you reinstall.
