Page 17 of 26
Contrast
0…100
Adjustment of contrast.
This allows the brighter area to be seen
more distinctly. The center point is in 50
position.
Note: for DVI-D signals the Contrast
setting is optimized.
Manual changes are not recommended.
Backlight
0…100
It is used to adjust the Brightness of the
monitor.
Color
Color1
Color2
Color3
User
R G B Gain
R G B Bias
Color 1, Color 2, Color 3 are three fixed
color temperature and can not be
changed. User temperature can be
adjustable and saved.
H Position
(Analog only)
0…255
Shift picture in horizontal direction
V Position
(Analog only)
0…255
Shift picture in vertical direction
Frequency
(Analog only)
0…100
Adjust the frequency and phase of the
input signal.
Hsync Phase
(Analog only)
0…63
Source clock phase
PhaseR
(Analog only)
R ADC clock phase
0…7
PhaseG
(Analog only)
G ADC clock phase
0…7
PhaseB
(Analog only)
B ADC clock phase
0…7
For compensate R,G,B phase for analog
long cable use.
Display
Settings
Sharpness
Interpolation filter -5
to 5
One of the 11 filters can be selected for
the sharpness setting to reduce scaling
artifacts. Interpolation filters depend on
the input resolution. Digital signals which
is used with 1280X1024 resolution can
not be adjusted since each pixel is
controlled by its own pulse. Other
digital signals which is lower than 1280 x
1024 can be adjusted. Analog signals
can be adjusted in all supported
resolution.
Negative figure is adjusted to get softer
image and positive figure is adjusted to
get sharper image. The user should
individually adjust the filter depending
on the application.
Input
Source
DVI-D
DP
VGA
Select the active input source priority.
If you call this OSD menu, the current
source is displayed. If current source is
inactive (NO sync) and, it will auto
search other port.
Auto Adjust
Auto-Color
ON / OFF
Automatically get input signal match
