泰智科技
Shenzhen Topwisdom Technology Co., Ltd
78
1
0
L
aser Set
2. P W M F r e q u e n c y ( H Z )
1. L a s e r T y p e
3. L a s e r M i n ( % )
4
a x
. L a s e r M
( % )
5. P W M D I R
6. F
ocus Length(mm)
ESC
Save
1 0 0
2 0 0 0 0
2014 03 10 11 00
-
-
:
C O 2
P o s i t i v e
Fig. 5-15
Press the ―Up/Down‖ key to select the needed operation. Press the ―Choose‖ key to
change setting, ―Number‖ keys to set the value.
Laser Type:
The common laser (CO2 glass tube), RF1, and the RF2. RF1 is for RF
laser without pre-ionize. RF2 is for RF laser with pre-ionize that will output 1us
tickle pulse.
PWM Frequency (HZ):
Press the ―Number‖ keys to change the PWM.
Laser Min/Max (%)
: Range: 0
≦
the min duty ratio
≦
the max duty ratio
≦
100.
PWM DIR:
Press ―Choose‖ to change the PWM DIR. If you found when you set
power bigger, the intensity of laser beam is stronger. Then you should change the
PWM DIR.
Focus Length (mm):
Press the ―Number‖ keys to change the focus length. When
this parameter is set. Press ―.‖ Dot key in standby interface, a message box will be
shown that if reset focus length. If press ―Enter‖, the laser head will go down
controlled by U Axis. When sensors close to the material surface, reach the
designated position, a signal is given to controller, then it controls the laser head
move up to the focus position.
Attention: if laser type is RF1 or RF2, set the PWM Frequency to 5000, Laser Max
to 95%, not to 100%, otherwise the laser would always be on or off.
5.4.2 Equipment Set
In the Integrate interface choose ―Equipment‖ to enter, show as:
Содержание TL-403
Страница 14: ...Shenzhen Topwisdom Technology Co Ltd 8 Fig 2 5...
Страница 36: ...Shenzhen Topwisdom Technology Co Ltd 30 Fig 3 21 Double click the System show as Fig 3 22 Fig 3 22...
Страница 37: ...Shenzhen Topwisdom Technology Co Ltd 31 Fig 3 23 Click the device management Fig 3 24 The assigned COM port...
Страница 41: ...Shenzhen Topwisdom Technology Co Ltd 35 Fig 3 30 Double click TCP IP setting Fig 3 31...
