TOPP K200, Инструкция по установке и эксплуатации

Страница: 46 / 56

5.6
PROGRAMMING PARAMETERS ON THE K200
ENTER DOWN
Code Description
Parameters set from digital switch or PC
Presence of electric lock ( without dot=electric lock not present )
Presence of battery ( without dot=battery present)
Partial opening (without dot=disabled =70%, with dot=enabled =40%)
Seal on closure ( without dot=disabled=0; with dot=enabled=Level 2 )
Automatic and partial reclosing time ( without dot=disabled=5 ; with dot=enabled=0 )
Opening speed adjustment at 45cm/s and closure at 25cm/s
Opening/closing speed increase at 45cm/s
Opening speed increase at 65cm/s and closure at 35cm/s
It is possible to enter the basic parameters using the 7 segment display (detail 11 fig.33 ) and the
<ENTER> and <DOWN> keys.
Press and hold <ENTER> for 5 sec to enter the configuration menu.
Press <DOWN> to pass from a parameter to another, press <ENTER> to enable/disable the
function.
The presence on the display of a dot next to a parameter code indicates that the function is enabled.
WITHOUT DOT-monitored sensors (with test) type Optex OA-Axist T or
Hotron HR100_CT
WITH DOT-NC not monitored sensors (without test connection)
Safety logic:
46
INSTRUCTIONS FOR INSTALLATION AND USE EN
K200
Not used
(Allows the use of "Wings free", if the automation board is set up for the "Wings free", function)
Change the function of the buttons on accessories TS1, TS2 and MS1 in the ”WINGS
FREE” Operating mode. ( with dot=enabled ; without dot=disabled )
If the TS2 remote control is available, pressing the button “Enter only” ,“Free Panels” operation mode is activated.
If the MS1 program selection knob is available, selecting “Enter only” , “Free Panels” operation mode is activated.
If the TS1 remote control is available, pressing the button “Open” , “Free Panels” operation mode is activated.
Pressing the button “Open” for more than 10 seconds, the “Open” operation mode activates.
Description of behavior / y parameter = with dot
To program the radio control devices (up to 8):
display.
To deactivate all radio control devices:
To confirm that all programmed remote controls have been deactivated, the sequence of characters "Radio" will no longer be
displayed.
2. If you have the Topp remote control TS2 press the smooth side of the first key (open function).
To confirm that the remote control has been memorized, the "Radio" character sequence will no longer be displayed.
2. Press the “DOWN” key and hold for a further 5 seconds, all remote controls connected to the electronic board will be
deactivated.
1. Press the “DOWN” key and hold for 5 seconds. The sequence of characters “Radio” appears on the 7-segment
If the Topp TS1 4- channel remote control is available, press the second key (Close Function).
1. Press the “DOWN” key and hold for 5 seconds, then release it. The sequence of characters “Radio” appears on the 7- segment
display.