TOPP K200, Инструкция по установке и эксплуатации

Страница: 21 / 56

3.9
INSTALLING THE CASING
21
INSTRUCTIONS FOR INSTALLATION AND USE
antivibration
felt
M3,5x9,5 screws for
fastening casing
A
Fig. 32
Fit the upper part of the casing in its housing on top of the beam, holding it in a tilted position at a 30° angle and insert it until
it is flush (
Fig.32 Ref.2 ).
Fasten the lateral caps on the beam using 3 screws type TSP d3.5x9.5 for each cap, supplied in the hardware package.
Apply an antivibration felt strip every 300mm along the beam (
Fig.32 Ref.1 ).
Fasten the casing to the beam using two more screws type TSP d3.5x9.5 ( Fig.32 Ref.3 ).
If it should not be possible to fasten the casing from the side, proceed as follows:
%
Drill symmetrical holes in the casing cover using a suitable drill with a Ø6.5 bit for aluminum, with the measurements
and position indicated in Fig.32 Ref.4
% Fasten the casing to the beam using the two screws type TCEI M5x10.
1
2
3
EN K200
4
M5x10 screws for
fastening casing
Rating place and
“CE” marking