TOPP K140, Инструкция по установке и эксплуатации

Страница: 14 / 56

3.5
FASTENING AND ADJUSTMENT OF THE SLIDING PANELS
To fasten the sliding panels to the crossbar, proceed as follows:
%
Lower the anti-derailing wheels of the carriages (Fig.14);
%
Bring the panels to the crossbar and make sure the gliding base of the carriages is clean and free of any scraps;
%
Fasten the door panel to the crossbar by raising it slightly and hooking it first on one side and then on the other, or both
sides at once (Fig.15);
%
Loosen the fastening screws on the carriages and insert the no. 10 fixed wrench in the height adjustment screw on the
carriage and turn it to the left or right so that the door panel is about 5 mm off the floor (height for the standard runner);
%
Determine the distance “A” for adjustment of the door panel (Fig. 17);
@
If an air seal brush must be installed between the sliding panel and the upright or wall, adjust the panel so that there is
a space of about 1 mm between it and the brush along the entire length;
%
Fasten the runner to the floor at point “A” using the anchor bolt and self-tapping screw d 6x70 contained in the hardware
package (Fig.16).
%
Adjust the distance “A” (Fig.17) by loosening the two screws that hold the lower bracket of the carriage to the adapter.
The holes on the brackets are in slot form to permit movement of the door by about 18 mm.
%
Before tightening the screws make sure the carriages are aligned with each other and with the crossbar.
%
Adjust the height of the sliding panels (Fig.18) using the special adjustment screws on the carriages (Fig.17). After
performing this operation, tighten the screws on the load-bearing wheels and raise the anti-derailing wheel.
@
Using the height adjustment screws on the carriages you can raise or lower the door by ±10mm (with the crossbar
installed on the basis of the measurements shown in Fig.8).
Load-bearing
wheels
Anti-derailing wheels
Height adjustment
Anti-derailing wheels
LEFT
Load-bearing wheels
Fastening screw
Adjustment screw
Carrello
RIGHT
Rear part of door panel
Fig. 15
Fig. 14
Fig.
16
14
Carriage
fastening screw Carriage
fastening screw
INSTRUCTIONS FOR INSTALLATION AND USE EN
K140