TOPP C30, Инструкция по установке и эксплуатации

Страница: 16 / 32

5.2- TOP HUNG WINDOWS
(Fig. 7 and Fig. 13, 24)
1) Open the package (par. 3.7) and extract the
various components;
2) Fig.13- With a pencil draw the centre line “X” of the
window frame;
3) Fig.14- Align to the centre line the semi-automatic
coupling using as reference the rib (Ref.1) located
in the middle of the same with the indicator on the
quick release side on the right
(Ref.2) ;
4) Fig.15- Place the semi-automatic coupling at a
minimum height of 10 mm from the frame and mark the drilling points;
5) Fig.16/17- Using a suitable drill, perform on the wing two holes of Ø 3.7 and tighten
the semi-automatic coupling with the suitable screws;
6) Fig.18- Align to the centre line the window frame connection bracket using as
reference the indicator of the centre line (Ref.1) located in the middle of the same;
7) Place the bracket on the frame at such a height as to align the axis of the bracket
fastening seat with the axis of the semi-automatic coupling fastening holes, as shown
in
Fig.19 and mark the drilling points;
8) Fig.20/21- With a suitable drill perform four holes of Ø 3.7 on the frame and fasten the
bracket with the suitable screws;
VERIFY THAT THE CHAIN ADJUSTMENT END (FIG.8-Ref.A) IS ON THE SAME AXIS OF
THE SEMI-AUTOMATIC COUPLING (FIG.8-Ref.B). OTHERWISE, REPEAT THE
PROCEDURES AND POSITION THEM CORRECTLY. IF THE TWO ELEMENTS ARE NOT
COAXIAL, THIS MAY DAMAGE THE ACTUATOR AND WINDOW FRAME (FIG.8).
Fig.7
Fig.8
A A
B B
NO YES
16
C30 5- INSTALLATION
INSTALLATION AND USE ISTRUCTIONS
VER.1.0
REV.07.04