- 15 -
gap between the square and the rip fence. When the square is flush against the rip fence re-tighten the
two 1/4
″
bolts from the side you are adjusting. If necessary, repeat the same steps for the other side.
(See Fig.26G)
7. Once both rip fences are secured in place slide the extruded aluminum angle bar firmly against
both rip fences and tighten in place for additional support.
Fig.26A
Fig.26B
Fig.26C
Fig.26D
Fig.26E
Fig.26F
Fig.26G
VII TROUBLE SHOOTING
Below we have listed a number of possible causes and corresponding solutions in case the machine
dose not function as it should:
●
The motor gets hot.
1. The ventilation slots in the motor are blocked with dirt:
-Clean the cool ventilation slots;
2. The motor is defective:
-Have your stone cutter repaired by your supplier.
●
The connected machine does not work.
1. Interruption in the mains connection;
-Check mains connection for fracture.
