Topens Casar MT8012, Руководство пользователя

Страница: 16 / 32

13
9.
Attach the gate brackets to each gate by inserting two M8x80
bolts through the gate brackets and the drilled holes in the gates.
Fasten each bolt with one
￠
8 lock washer, and one
￠
8 nut.
10. With the opener fully retracted and with the gate in the fully
closed position (for Push-to-Open installation), attach the gate
opener to the Post Bracket Assembly and the Gate Bracket by
inserting a thread pin through the gate opener and the Push to Open
Bracket and another thread pin through the gate opener and the
Gate Bracket.
11. Open the release hole plug on the top of the gate opener, insert the release key, and turn the key 90°
counterclockwise. This restores normal operation.
NOTE: The setting of the PULL/PUSH TO OPEN of the control board should be in accordance with the
installation.
Mounting the Control Box
Step 1
To install the control box use the deck screws (not provided).
Even though the control box is waterproof designed, for safety reason
and a longer service life, it is recommended to install the control box
inside a secure surface and at least 100 cm (40 inches) above the
ground to avoid being flooded or buried under snow.
Step 2
Insert the power cable and cable of the first gate opener through the front
strain relief and into the control box by loosening the strain relief screw
located in the leftmost of outside bottom of the control box and feeding the
cables into the control box. Check the length of cables is long enough to
their respective terminal block in control box.