Topcon HiPer V, Руководство оператора

Страница: 53 / 122

Configuring the Receiver
Loading New Firmware
40 P/N: 1001608 ‐ 01
Figure 18: Finishing Firmware Upload
To load the main board firmware file to the receiver:
1. Perform a factory reset on the receiver. See “Performing a Factory Reset (Clearing the NVRAM)” on page 45.
2. Remove the storage card from the receiver. See “To install/remove the SD/SDHC card:” on page 56.
3. On the storage card, create a “Firmware” folder, and copy the acpu.sbc file into the folder.
4. Insert the storage card back into the receiver.
5. Power on the receiver. The receiver will power up 20 to 30 seconds slower than normal. The |0|0| LED begins to
flash, indicating the firmware is uploading.