Topcon 3D-MC2, Инструкция по установке и калибровке

Страница: 28 / 32

3D-MC² Setup and Calibration
3D-MC² Installation and Calibration Manual
4-14
Figure 4-18. Match Mast Angle and Mainfall Slope Angle
5. Press
Mainfall slope Set
on the
Adjust Slope
screen, and enter the
measured slope value. Press
Set
again to save the value.
Figure 4-19. Set Mainfall Slope
6. Place the machine on a different main slope to verify that the
value is correct.
90°
Angle of Mainfall Slope = 2%
Angle of Mast = 2%
Adjust Mast Angle
to Match Angle of
Mainfall Slope