Topcom BABYTALKER 2100, Руководство пользователя

Страница: 8 / 54

8 Topcom Babytalker 2100
Topcom Babaytalker 2100
When the battery level is low, the power LED (7) will blink.
5.5 Link
Do not place the baby unit or cables in the crib or within the arm reach of the baby
(at least 1 meter away).
When using the Babytalker the first time, it is adviced to test the connection.
•
Install the parent unit in the same room as the baby unit, but have at least 1 meter
between the 2 units.
• When both units are switched on, the parent unit will search for the baby unit.
• The green link LED (3) on Parent Units will flash until they communicate. Once the link is
established, the LED (3) will light continuously. After a while, when the baby unit doesn’t
capture any sound, the LED (3) will flash every 5 seconds because the baby unit stops
the transmission.
• The voice captured by the microphone will be audible on the parent unit.
• The level of the detected speech is represented by the LED’s (1) on top of the parent
unit.
• When the speech reached the maximum level, a beep will be audible.
• When the connection is established, move the parent unit to the monitor room, but within
the operation range.
• Test the range again by pressing shortly the power (2) key. When there is no connection,
an alert signal (double beep) will be audible (out of range warning) and the green
connection LED will blink.
• Move the parent unit closer until the link is re-established. If there is connection, a long
beep will be audile and the green connection led will light continuously.
6 Using the Babytalker 2100
6.1 Volume adjustment
There are 5 volume levels on the parent unit.
•
Press the volume up (9) button to increase the volume level.
• Press the volume down (8) button to decrease the volume level.
6.2 Night Light
• Press the Night Light button (13) on the baby unit. The night light (17) will illuminate.
• Press the Night Light button (13) again to switch the light off.
6.3 Sound alert
The babies voice detection level is indicated by the number of volume indicator LED’s (1) on
top of the parent unit.
Only when the volume of the parent unit is set to
‘Off’ , a beep can inform you when the voice
level reached the red led zone.
6.4 Paging
When your parent unit is lost, you can track it by pressing the paging button on the baby unit
for 2 seconds.